What If There Are Problems - Korona Diana Manual De Instrucciones

14

What if there are problems?

If the scale detects and error when measuring, the following is displayed.
Display
Err
LO
– – – –
no measurement possible
Possible errors
The User mode has been incorrectly acti-
vated. If you stand on the scales to measure
all body values before the display shows
"0.0 kg", the scales will not function correctly.
The batteries in the scale are empty.
incorrect weight measurement
Possible errors
Scale is on carpeting.
Incorrect zero point of scale.
26
Cause
The maximum load capacity of
150 kg was exceeded.
The batteries are almost empty.
The electrical resistance between
the electrodes and the sole of your
foot is too high (e.g. if you have
tough calluses).
The fat percentage is outside the
measurable range (less than 4% or
greater than 70%).
The personal values entered are
outside normal ranges (e.g. height is
too small).
Remedy
Do not load the unit with over
150 kg.
Replace the batteries
Repeat the measurement barefoot.
If necessary, moisten the soles
of your feet slightly. If necessary,
remove the calluses from the soles
of your feet.
Repeat the measurement barefoot
or, if necessary, moisten the soles
of your feet slightly.
Check and if necessary correct the
saved personal values.
Remedy
Correctly activate User mode (wait
for "0.0 kg" to be shown) and repeat the
measurement.
Replace the batteries.
Remedy
Place the scale on a level and solid surface.
Activate the scale,
wait approximately 4 seconds,
repeat measurement.