Important; Weather Forecast And Pressure Trend Indicators; Weather Icons; Weather Tendency Arrows - La Crosse Technology WS-7394U-IT Manual Del Usuario

7. Insert the batteries to the third sensor as soon as the "channel 2"
icon and outdoor data are displayed on the Weather Station. Then
within 2 minutes, the channel 3 outdoor data from the third sensor
will be displayed and the channel icon will shift back to "1" once the
third transmitter is successfully received. If this is not happen, user
shall restart the setting up from step 1.
NOTE: You must insert the batteries into the third sensor within 10
seconds of reception of the second sensor.
IMPORTANT: Transmission problems will arise if the setting for mul-
tiple sensors is not followed as described above. Should transmission
problems occur, it is necessary to remove the batteries from all units
and start again the set-up from step 1.
C. Viewing and Operating with Multiple Remote Sensors
a. To view the temperature of a different remote sensor press and
release the "CH" button. A shift from one "boxed" number to the
next should be observed in the OUTDOOR LCD.
b. The minimum and maximum temperature of the additional remote
sensor can be displayed by pressing the "OUT/+" button.
c. To reset the minimum and maximum temperature readings press
and hold the "SET" button for 3 seconds and that temperature record
for that remote sensor will be reset only.
Each remote sensor will have its own minimum and maximum values
stored.
D. Comfort Indicator for Indoor Temperature and Humidity
1. The comfort level indicator appears inbetween the indoor
tempearture and humidity.
2. The indicator will display a "happy-face" when the temperature is
between 68˚F and 79˚F (20˚C and 25.9˚C), and the humidity is
between 45% and 65%.
3. A "sad-face" will be displayed when the temperature and humidity
are outside the mentioned ranges.
E. Weather Forecast Icon and Pressure Trend Indicators
The weather forecasting feature is estimated to be 75% accurate, and
is based solely upon the change of air pressure over time. The WS-
7394U-IT averages past air-pressure readings to provide an accurate
forecast-creating a necessity to disregard all weather forecasting for
12-24 hours after the unit has been set-up, reset, or moved from one
altitude to another (i.e. from one floor of a building to another floor). In
areas where the weather is not affected by the change of air pressure,
this feature will be less accurate.
GB
P.18

1. Weather Icons

There are 3 possible weather icons that will be displayed at various
times in the center of the indoor weather station.
a. Sunny-indicates that the weather is expected to improve (not that
the weather will be sunny).
b. Sun with Clouds-indicates that the weather is expected to be fair
(not that the weather will be sunny with clouds).
c. Clouds with Rain-indicates that the weather is expected to get worse
(not that the weather will be rainy).
1. The weather icons change when the unit detects a change in air
pressure.
2. The icons change in order, from "sunny" to "sun with clouds" to
"clouds with rain" or the reverse.
3. It will not change from "sunny" directly to "clouds with rain", although
it is possible for the change to occur quickly.
4. If the symbols do not change, the weather has not changed (or the
change has been slow and gradual).
5. The sensitivity of the change in foreacst icon is set by the user in
section O of the Detailed Set Up Guide.
F. Weather Tendency Arrows
Pressure trend arrow
1. Along with the forecast icon there is a pressure tendency arrow.
2. There is one that points up (on the left side of the LCD) and one
that points down (on the right side of the LCD).
3. These arrows reflect current changes in the air pressure.
4. An arrow pointing up indicates that the air pressure is increasing
and the weather is expected to improve or remain good.
5. An arrow pointing down indicates that the air pressure is decreas-
ing and the weather is expected to become worse or remain poor.
G. Barometric Air Pressure Reading
1. The actual barometric air pressure is displayed directly under the
weather forecast icon
2. The relative air pressure is calibrated by the user through the pro-
gramming mode.
3. Please Follow the programming instructions in section N of the De-
tailed Set Up Guide to set this feature.
GB
P.19