Air Pressure History Bar Chart; Mounting - La Crosse Technology WS-7394U-IT Manual Del Usuario

H. Air Pressure History Bar Chart
1. The bar chart indicates the air pressure history trend over the last
12 hours in 5 steps, 0h, -3h, -6h, -9h, and -12h.
2. The "0h" represents the current full hour air pressure recording.
3. The columns represent the "hPa" (0, ±2, ±4) at specific time.
4. The "0" in the middle of this scale is equal to the current pressure
and each change (±2, ±4) represents how high or low in "hPa" the
past pressure was compared to the current pressure.
5. If the bars are rising it means that the weather is getting better due
to the increase of air pressure.
6. If the bars go down, it means the air pressure has dropped and the
weather is expected to get worse from the present time "0h".
Note: For accurate barometric pressure trends, the Weather Station
should operate at the same altitude for example, it should not be moved
from the ground to the second floor of the house. Should the unit be
moved to a new location, discard readings for the next 12-24 hours.
This feature cannot be turned off.
VII. MOUNTING
Note: Before permanently mounting, ensure that the Wireless Weather
Station is able to receive signals from the transmitters and WWVB
signal at the desired location. To achieve a true temperature reading,
avoid mounting the remote temperature sensor (or any sensor) where
direct sunlight can reach the remote sensor. We recommend that you
mount the remote sensor on a North-facing wall or under an eve. The
sending range of the remote temperature sensor is 330-ft (100m) how-
ever obstacles such as walls, concrete, and large metal objects can
reduce the range. Place all units in their desired location, and wait
approximately 15 minutes before permanently mounting to ensure that
there is proper reception. If the Wireless Weather Station loses the
signal from the remote sensor, it will display the last temperature read-
ing for 15 minutes. After 15 minutes of not receiving any signals, the
remote temperature will display "- -.-".
A. Mounting the Remote Temperature Sensor
The remote temperature sensor can be mounted in two ways:
• with the use of screws
• using the adhesive tape
GB
P.20
1. MOUNTING WITH SCREWS
a. Remove the mounting bracket from the remote temperature sensor.
b. Place the mounting bracket over the desired location.
c. Through the three screw holes of the bracket, mark the mounting
surface with a pencil.
d. Screw mounting bracket onto the mounting surface. Ensure that
the screws are flush with the bracket.
e. Insert the remote temperature sensor into the bracket.
2. MOUNTING WITH ADHESIVE TAPE
a. With a nonabrasive solution, clean and dry the back of the mount-
ing bracket and the mounting surface to ensure a secure hold. The
mounting surface should be smooth and flat.
b. Remove the protective strip from one side of the tape.
c. Adhere the tape to the designated area on the back of the mount-
ing bracket.
d. Remove the protective strip from the other side of the tape.
e. Position the remote temperature sensor in the desired location, en-
suring that the Wireless Weather Station can receive the signal.
GB
P.21