Wall Mounting; Maintenance And Care - La Crosse Technology WS-7394U-IT Manual Del Usuario

Note: Mounting with adhesive tape is not recommended as a perma-
nent mounting solution. Only use the adhesive tape during set-up
process.
B. Mounting the WS-7394U-IT Wireless Weather Station
The Wireless Weather Station can be mounted in two ways:
• with the table stand
• on the wall with the use of a wall hanging screw (not included)
1. USING THE TABLE STAND
The indoor weather station comes with the table stand already mounted.
If you wish to use the table-stand all that is required is to place the
indoor weather station in an appropriate location.

2. WALL MOUNTING

a. Remove the table-stand. To do this, pull down on the stand from
the rear and rotate forward.
b. Fix a screw (not included) into the desired wall, leaving approxi-
mately 3/16 of an inch (5mm) extended from the wall.
GB
P.22
c. Place the indoor weather station onto the screw using the hanging
hole on the backside.
d. Gently pull the indoor weather station down to lock the screw into
place.
Maintenance and Care Instructions
A. Extreme temperatures, vibration, and shock should be avoided to
prevent damage to the units.
B. Clean displays and units with a soft, damp cloth. Do not use sol-
vents or scouring agents; they may mark the displays and casings.
C. Do not submerge in water.
D. Immediately remove all low powered batteries to avoid leakage and
damage.
E. Opening the casings invalidates the warranty. Do not try to repair
the unit. Contact La Crosse Technology for repairs.
TROUBLESHOOTING
Problem: The LCD is faint.
Solution:
1. Set the LCD contrast to a higher level.
2. Replace batteries.
Problem: No outdoor temperature is displayed.
Solution:
1. Remove all batteries, reinsert into the remote temperature sensor
first, then into the indoor weather station.
2. Place remote temperature sensor closer to the indoor weather
station.
3. Be sure all batteries are fresh.
4. No other interfering sources are being used (such as computer
monitors, TV sets, headphones, or speakers) in the vicinity. The
signal travels in a straight line, an electrical source near that "line"
may cause interference.
Problem: Temperature, humidity, or air pressure is incorrect.
Solution:
1. Check/Replace batteries.
2. If multiple remote sensors are in use, check location with corre-
sponding "boxed numbers."
3. Move away from sources of heat/cold.
4. Adjust relative air pressure to a value from a reliable source (TV
radio, etc.).
5. The indoor weather station and remote sensors are calibrated at
the factory. If there is a consistent problem, please call La Crosse
Technology.
GB
P.23