Flotec FPSC2200A Manual Del Usuario página 5

Operation
1. The shaft seal depends on water for
lubrication. Do not operate the pump unless
it is submerged in water; running it dry may
damage the seal.
2. If the pump overheats, an automatic-reset
thermal protector cuts off the power and stops
the motor before it can be damaged. The motor
will automatically restart when it cools. If the
protector trips repeatedly, unplug the pump,
remove it from the sump, and check it for
the cause of the difficulty. Low voltage, long
extension cords, clogged impeller, very low lift,
a plugged or frozen discharge pipe, etc., can
all cause cycling and overheating.
3. This pump will not remove all the water in the
sump. If you are running the pump manually
and water stops coming out of the discharge,
the pump has probably run dry. Shut it off
immediately and check the water level.
Figure 7 – LIFT: Lift is the vertical distance the
pump actually lifts water. The higher the lift, the
lower the flow.
For parts or assistance, call Flotec Customer Service at 1-800-365-6832
Discharge
Pipe
Performance
GPH At Total Feet Of Lift (See Figure 7)
5 ft.
Model
Capacity Gallons/Hour
FPSC2200A 4,020
FPSC2250A 4,020
FPSC3200A 4,380
FPSC3250A 4,380
FPSC4550A 4,700
Electrical & Switch Specifications
Motor
Motor
Model
HP
Amps
FPSC2200A 1/3
FPSC2250A 1/3
FPSC3200A 1/2
FPSC3250A 1/2
FPSC4550A 3/4
Basement
Floor
Sump
Pit
Check Valve
(Install Vertically)
NOTICE : The friction caused by water running
through the pipe will also, on longer pipe runs,
reduce the flow.
10 ft. 15 ft. 20 ft.
3,540 3,000 1,800
3,540 3,000 1,800
3,840 3,300 2,340
3,840 3,300 2,340
4,100 3,500 2,820
*Switch Setting
Individual
in inches
Branch
Full
Water Level
Circuit
Load
For:
Req.
(Amps)
On
6.9 15 15"
6.9 15 6-1/2"
7.0 15 15"
7.0 15 6-1/2"
7.7 15 6-1/2"
Lift
5
No flow
at height
shown
below
26'
26'
28'
28'
32'
Off
7"
3"
7"
3"
3"