Special Operation - Mitsubishi Electric PAR-SL101A-E Serie Manual De Instrucciones / Manual De Instalación

5. Special Operation

E
en
2
A
14
D
1
6
3
4
5
Fig. 5-1
Fig. 5-2
C
B
Fig. 5-3
Some functions cannot be operated depending on the air
conditioner.
Confi rm whether the air conditioner supports each func-
tion, and then operate the air conditioner.
<Switching to the special operation mode>
(Fig. 5-1, Fig. 5-2)
1. Press the button 1 to stop the air conditioner.
• If the weekly timer is enabled, press the
2 to disable the timer. (
2. Press the button 3.
• The Function setting screen will be displayed and the
function No. A will blink.
<Transmitting the settings> (Fig. 5-1)
• When you perform each operation,
controller display blinks to indicate that the
ton 4 must be pressed to transmit the settings. Point
the transmission area of the wireless remote controller
towards the receiver on the indoor unit and press the
button 4 to transmit the settings. Confi rm that the
indoor unit beeps at this time.
<Exiting the special operation mode> (Fig. 5-1, Fig. 5-2)
1. While the operation screen for each function is displayed,
press the button 3 or the
• The Function setting screen will be displayed and the
function No. A will blink.
2. Press the button 3.
• The display returns to the normal screen.
5.1. Setting the fi xed airfl ow direction
(Fig. 5-1, Fig. 5-3, Fig. 5-4)
<Setting the vertical airfl ow direction>
1. In the Function setting screen, press the
select function No. "2".
2. Press the button 4.
• The vane number B blinks.
3. Press the button 6 to select the vane number.
• For information about the vane numbers, refer to the
indoor unit operation manual.
4. Press the button 4.
• The airfl ow direction setting C blinks.
5. Press the button 6 to select the airfl ow direction at
which you want to fi x the vane.
Step 1 Step 2 Step 3
Draft reduction No setting
(No display)
6. Press the button 4 to transmit the settings.
Note:
Draft reduction
The airfl ow direction for this setting is more horizontal than
the airfl ow direction for the "Step 1" setting in order to re-
duce a drafty feeling. The draft reduction can be set for
only 1 vane. The setting is enabled only for the last vane
that was set.
button
E disappears.)
D on the remote
but-
button 5.
button 6 and
Step 4 Step 5