Mitsubishi Electric PAR-SL101A-E Serie Manual De Instrucciones / Manual De Instalación página 36

7. Service
en
18
5. Press the button 4 to set the mode number.
• While pointing the wireless remote controller toward
the receiver, press the
number blinks.)
At this time, the beeper sound and OPERATION IN-
DICATOR lamp blinking pattern indicate the current
setting number for the selected mode number.
Current setting value = 1: Beep (1 sec.) × 1 time
* If you enter a mode that cannot be set, the beeper
sounds 3 times continuously "beep, beep, beep (0.4
+ 0.4 + 0.4 sec.)".
If this occurs, press the
set the mode number again while the mode number
display is blinking.
* If the signal was not received correctly, the beeper
will not sound or it will beep twice.
If this occurs, press the
set the mode number again while the mode number
display is blinking.
6. Press the button 4 to select the setting number.
• While pointing the wireless remote controller toward
the receiver, press the
number blinks.)
At this time, the beeper sound and OPERATION IN-
DICATOR lamp blinking pattern indicate the setting
number for the selected mode number.
Current setting value = 1: Beep (1 sec.) × 1 time
* If you enter a number that cannot be set, the origi-
nally set number will be used.
* If the signal was not received correctly, the beeper
will not sound or it will beep twice.
If this occurs, repeat the procedure from step 5.
7. To set another mode without changing the unit number
of the indoor unit, repeat steps 5 and 6.
8. To change the unit number of the indoor unit and
perform the function selection, repeat steps 4–6.
9. Press the button 1 to complete the function
selection.
Note:
● After the function selection is complete, do not
operate the wireless remote controller for 30
seconds.
● Whenever the function selection is used to
change the indoor unit functions after installa-
tion, be sure to record all of the settings with a
"○" or other mark in the "Initial setting" column
of the table.
button 5. (The setting
= 2: Beep (1 sec.) × 2 times
= 3: Beep (1 sec.) × 3 times
button 6, and then
button 6, and then
button 5. (The mode
= 2: Beep (1 sec.) × 2 times
= 3: Beep (1 sec.) × 3 times