Rectifying Malfunctions - geberit Piave Manual Del Usuario

EN

Rectifying malfunctions

Malfunction
Water jet too weak
No flush actuation
Water runs
continuously
Unwanted flow of
water, either too
soon or delayed
Water drips from the
tap housing
Red LED flashes
during flush
actuation
Skilled persons will find further information on troubleshooting on the website of the respective Geberit sales
company.
14
Cause
Tap aerator dirty
Basket filter clogged
Pipe pressure too low
Pipe pressure too low
Network failure
Batteries dead or rechargeable battery
empty
Technical fault
Technical fault
IR window is dirty or wet
IR window scratched
Detection distance of the IR sensor not
set correctly
Technical fault
Batteries almost dead or rechargeable
battery almost empty
Rectification
▶ Clean the tap aerator. → See "Cleaning
the tap aerator", page 16
▶ Clean the basket filter. → See
"Cleaning the basket filter", page 16
▶ Contact a skilled person.
▶ Contact a skilled person.
▶ Check the power supply.
▶ Replace batteries or charge
rechargeable battery for generator
operation. → See "Replacing the
batteries", page 17 and "Checking and
charging the rechargeable battery for
generator operation", page 17
▶ Contact a skilled person.
▶ Shut off water supply and contact a
skilled person.
▶ Clean or dry the IR window.
▶ Contact a skilled person.
▶ Contact a skilled person.
▶ Shut off water supply and contact a
skilled person.
▶ Replace batteries or charge
rechargeable battery for generator
operation. → See "Replacing the
batteries", page 17 and "Checking and
charging the rechargeable battery for
generator operation", page 17
45035998285466763-1 © 03-2020
967.455.00.0(02)