Transport, Storage, Decommissioning And Disposal - Columbus McKinnon YLITP ATEX 500 Instrucciones De Servicio

Recommended lubricants
Brake thread: Teccem e.K. 708 W Plus Neu
Chain lubrication: Shell Tonna, T68 Rocol M070, Rocol MV 3
Gear and bearing seat lubricant: Gleitmo 805K, drip point > 130°C
Repairs may only be carried out by authorized specialist workshops that use original
Yale spare parts.
After repairs have been carried out and after extended periods of non-use, the hoist must be
inspected again before it is put into service again.
Supervision
Every 3 years, the unit must be assessed by a competent person or an authorised service
partner. During this inspection, the unit is completely disassembled and all components are
subjected to a detailed assessment.
If this inspection is not carried out by a competent person or an authorised service partner, the
ATEX declaration of conformity is rendered invalid.
The inspections have to be initiated by the operating company.
T , S , D D
RANSPORT TORAGE ECOMMISSIONING AND ISPOSAL
Observe the following for transporting the unit:
• Do not drop or throw the unit, always deposit it carefully.
• Hand chains and load chains must be transported in a way to avoid knotting and formation of
loops.
• Use suitable transport means. These depend on the local conditions.
Observe the following for storing or temporarily taking the unit out of service:
• Store the unit at a clean and dry place.
• Protect the unit incl. all accessories against contamination, humidity and damage by means
of a suitable cover.
• Protect hooks against corrosion.
• A light lubricant film should be applied to the chains.
• Since the brake disks may freeze at temperature below 0 °C, the unit should be stored with
closed brake. Turn the hand chain wheel clockwise to this effect and hold the load fall at the
same time.
• In the case of models with integral trolley, grease the load bar as well as both threaded rods
to protect them against corrosion.
• If the unit is to be used again after it has been taken out of service, it must first be inspected
again by a competent person.
Disposal
After taking the unit out of service, recycle or dispose of the parts of the unit in accordance
with the legal regulations.
Further information and operating instructions for download can be found at
www.cmco.eu!