5.4
Inserting the foil pack holder and foil pack
CAUTION
Risk of injury Compressed-air hazard.
▶ Keep your hands well clear of the piston.
1. Press the return button and hold it down until the piston has fully retracted.
2. Push the foil pack holder into the cradle from the side.
3. Turn the foil pack holder in two steps (double click) through 45 ° in the cradle.
5.5
Setting metered dispensing
▶ Set the metered-dispensing switch to the desired setting.
5.6
Preparing the tool for use
▶ Press the piston advance button.
The amount of mortar to be discarded depends on the type of mortar used. Discard the amount
of mortar stated in the instructions for the foil pack.
5.7
Injecting mortar
WARNING
Risk of injury Falling materials hazard.
▶ In the event of non-compliance with the instructions for use, the load-bearing capacity of the fastening
is not ensured.
Use the mortar only within the specified temperature range.
The drillhole has to be filled with the requisite quantity of mortar without any air being trapped in the hole.
1. Insert the mixing nozzle into the drillhole until the tip of the nozzle is touching the bottom of the hole.
Use an extension if the drillholes to be filled are extra-deep.
2. Press the piston advance button and slowly withdraw the mixing nozzle from the drillhole.
5.8
Return function
CAUTION
Risk of injury Compressed-air hazard.
▶ Keep your hands well clear of the piston.
▶ Press the return button.
5.9
Removing the foil pack
CAUTION
Risk of injury Compressed-air hazard.
▶ Keep your hands well clear of the piston.
1. Press the return button and hold it down until the piston has fully retracted.
2. Turn the foil pack holder in two steps through 45 ° in the cradle.
3. Pull the foil pack holder to the side and out of the cradle.
4. Pull the foil pack forward and out of the foil pack holder.
If a partly emptied foil pack is going to be re-used, always leave it in the foil pack holder in the
product.
376427
*376427*
Printed: 18.05.2018 | Doc-Nr: PUB / 5103003 / 000 / 05
4
5
6
7
8
3
English
11