Installation Space - Kaco blueplanet 50.0 TL3 M1 WM OD IIGS Manual Del Usuario

CAUTION
Property damage due to gases that have an abrasive effect on surfaces when they come into contact
with ambient humidity caused by weather conditions.
The device housing can be seriously damaged due to gases in combination with air humidity resulting from
weather conditions (e.g. ammonia, sulphur).
› If the device is exposed to gases, the installation must be carried out at observable locations.
› Perform regular visual inspections.
› Immediately remove any moisture from the housing.
› Ensure adequate ventilation at the installation location.
› Immediately remove dirt, especially on vents.
› Failure to observe these warnings may lead to device damage which is not covered by the manufac-
turer warranty.
NOTE
Access by maintenance personnel for service
Any additional costs arising from unfavourable structural or mounting conditions shall be billed to the cus-
tomer.

Installation space

ž As dry as possible, climate-controlled, the waste heat must be dissipated away from the device.
ž Unobstructed air circulation.
ž Close to the ground, accessible from the front and sides without requiring additional resources.
ž Protected on all sides against direct weather exposure and sunlight (thermal heating) in outdoor areas. Implementa-
tion where necessary via constructional measures, e.g. wind breaks.
ž For easy operation during installation, ensure that the display is slightly below eye level.
Installation surface
ž Must have adequate load-bearing capacity
ž Must be accessible for installation and maintenance
ž Must be made out of heat-resistant material (up to 90 °C )
ž Must be flame resistant
ž Minimum clearances to be observed during installation: [See figure 8] [} Page 16]
Fig. 3: Device for outdoor installation
Page 14
Fig. 4: Intended installation location
<20°
KACO blueplanet 50.0 TL3