Unpacking The Device; Fastening The Mount - Kaco blueplanet 50.0 TL3 M1 WM OD IIGS Manual Del Usuario

6.2

Unpacking the device

CAUTION
Risk of injury caused by excessive physical strain.
Lifting the device, for transport, relocation and assembly, can result in injuries (e.g. back injuries).
› Only lift the device using the openings provided.
› The device must be transported and installed by at least 2 persons.
1
6
5
4
Fig. 5: Open the package
Legend
1 Cover
2 Side section - upper
3 Clamp (4x)
↻ The device is transported to the installation location.
1 Remove the plastic band from the pallet and packaging.
2 Pull the clamp off the packaging.
3 Pull the hood upwards to remove it and place the cardboard packaging to one side together with the mount and ac-
cessories.
4 Set the unit with base and side sections upright.
5 Remove the top side section and base from the device.
» If the unit is in the correct installation position: Proceed with the installation of the mount.
6.3

Fastening the mount

CAUTION
Hazard when using unsuitable fixing materials!
If unsuitable fixing materials are used, the device could fall and persons in front of the device may be seri-
ously injured.
› Use only fixing materials that are suitable for the mounting base. The fastening materials supplied are
only suitable for masonry and concrete.
› Only install the device in an upright position.
KACO blueplanet 50.0 TL3
2
3
DETAIL Z4:1
Z
Fig. 6: Setting the device upright
4 Base
5 Side section - lower
6 Cardboard packaging with mount and mounting kit
Page 15