DANGER! Risk of electric shock due to moisture
• This device must never be operated close to a bathtub, shower, filled hand basin or similar.
• The motor block, the power cable and the mains plug must not be immersed in water or any other
liquids.
• Protect the motor block against moisture, drips and splashes.
• If liquid gets into the motor block, remove the mains plug immediately. Have the device checked
before reusing.
• Never touch the device with wet hands.
• If the device falls into water, disconnect the mains plug immediately. Only then is it safe to retrieve
the device.
• Fill the vessel with a maximum of 200 ml of liquid in order to prevent liquid from getting into the
motor block.
DANGER! Risk of electric shock
• Only insert the mains plug into the wall socket after the device has been completely assembled and
filled.
• Only connect the mains plug to a properly installed and easily accessible wall socket whose voltage
corresponds to the specifications on the rating plate. The wall socket must continue to be easily
accessible after the device is plugged in.
• Ensure that the power cable cannot be damaged by sharp edges or hot points.
Do not wrap the power cable around the device.
• The device is not fully disconnected from the power supply, even after it is switched off. In order to
fully disconnect it, pull out the mains plug.
• When using the device, ensure that the power cable cannot be trapped or crushed.
• When removing the mains plug, always pull the plug and never the cable.
• Disconnect the mains plug from the wall socket...
... if there is a fault,
... when you are not using the multi chopper,
... before you assemble or disassemble the multi chopper,
... before you clean the multi chopper, and
... during thunderstorms.
• Do not use the device if there is visible damage to the device or the power cable.
• To avoid any risk, do not make modifications to the device. You also must not replace the power cable
yourself. Repairs must be carried out by a specialist workshop or the Service Centre.
DANGER! Risk of injury from cutting
• The blade insert is sharp. Handle it with care. When washing manually, the water should be sufficiently
clear that you can see the blades easily.
• The device must never be operated without the vessel.
• Never reach into the rotating blades. Do not touch rotating parts with spoons or similar utensils. Keep
long hair or loose clothing away from rotating parts as well.
• The blade insert continues to rotate after the device is switched off. Wait for it to stop moving before
you remove the working cover.
WARNING! Risk of material damage
• The maximum filling level for solid food is 350 ml.
• The maximum filling volume for liquids (e.g. cream) is 200 ml.
• The device is designed for a maximum operating time of 1 minute without interruption.
After this, the device must remain switched off until it has cooled down to room temperature.
• In order to avoid damage to the device, interrupt the mixing process immediately if the blade insert
/ cream attachment does not rotate or only rotates slowly.
Pull out the mains plug and check whether there is something in the vessel blocking movement or
whether the food is too tough. Also check whether the device is assembled correctly.
- 10 -