Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: Wherever possible, work with well cooled whipping cream (refrigerator temperature),
so that the whipped cream reaches a firm consistency.
Whipping cream
1. Place the vessel 7 on the vessel cover 9.
2. Carefully place the cream attachment 5 onto the blade insert 6 from above.
3. Place the blade insert 6 together with the cream attachment 5 onto the spindle 8 in the vessel.
4. Pour the cooled whipping cream (maximum 200 ml) into the vessel 7.
5. Place the working cover 4 onto the vessel 7 in such a way that the two small tabs on the working
cover fit into the grooves in the vessel and rotate the working cover clockwise until it clicks into place.
6. Place the motor block 3 into the upper edge of the working cover 4.
NOTE: The motor block does not fit onto the working cover entirely straight on the right-hand side.
7. Press down on the motor block 3 and hold it pressed down for approx. 30 to 50 seconds.
Check the result while doing so.
Remove food
NOTE: You can choose to use the vessel cover 9 as the cover or the base (Figure G).
1. Disconnect the mains plug 2 from the wall socket.
2. Remove the motor block 3.
3. Rotate the working cover 4 anti-clockwise and remove it.
4. Carefully remove the blade insert 6 (if necessary together with the cream attachment 5) from the
vessel 7.
5. Remove the food, e.g. using a spatula.
6. Clean the device as soon as possible after use.
Cleaning
Clean the device prior to its first use!
DANGER! Risk of electric shock!
• Pull the mains plug 2 out of the wall socket before you clean the multi chopper.
• The motor block 3, the power cable and the mains plug 2 must not be immersed in water or any other
liquids.
DANGER! Risk of injury from cutting!
When washing manually, the water should be sufficiently clear that you can see the blade insert 6 easily.
WARNING! Risk of material damage!
Do not use any astringent or abrasive cleaning agents.
Dismantling the device
1. Pull out the mains plug 2.
2. Remove the motor block 3.
3. Rotate the working cover 4 anti-clockwise and remove it.
4. Carefully remove the blade insert 6 (if necessary together with the cream attachment 5) from the
vessel 7.
5. Figure A: Carefully press the blade insert 6 downwards out of the cream attachment
6. Remove the vessel cover 9 from the vessel 7.
How to clean properly
1. If necessary, wipe down the motor block 3 and the power cable 2 with a damp cloth. Ensure that the
- 13 -
Publicidad
