Sinbo SK 7315 Manual De Instrucciones página 7

ENGLISH
SINBO SK 7315 KETTLE
INSTRUCTION MANUAL
1. COMPONENTS
1) Cover
2) Handle
3) Neon light
4) On / Off Switch
5) Base
6) Housing
7) Water scale
8) Spout
2. INSTRUCTIONS
1. When pouring water into the kettle, the water level must be kept within the range of the
maximum and minimum water levels set by the water scale 7) (as indicated in the picture).
2. Place the kettle base firmly on the stand, insert the plug into the socket, switch it on, and the
water will start to be heated up when the indicative light on 4) (as indicated in the picture).
3. When the water boils the switch will automatically bounce up, the indicative light will go out,
and the kettle will automatically cut off the electricity. If the water in the kettle is to be re-
boiled, one should wait a few minutes until the contact of the automatic device if restored (as
indicated in the picture).
4. Before using for the first time fill to max with water, boil; discard the water and then rinse.
Warning: Ensure there is water in the kettle when it is plugged in.
IMPORTANT INSTRUCTIONS
1) Please read these instructions before operating and retain for future reference.
2) This kettle is only to be used for boiling water,
3) To protect against electrical hazard do not immerse any part of the appliance or cord in water
or any other liquid.
4) Close supervision is necessary when the appliance is used near children.
5) Do not leave the appliance unattended when in use.
6) Always use the appliance on a dry, level surface.
7) Don't pour water in or out of the kettle if it is plugged in.
8) Do not use this appliance outdoors. This appliance is intended to be used in household and
similar applications such as: staff kitchen areas in shops, offices and other working environments;
farm houses; by clients, motels and other residential type environments; bed and breakfast
type environments.
9) Always unplug from the plug socket when not in use and before cleaning.
10) Do not operate the appliance if damaged after an appliance malfunctions or it has been
damaged in any manner, return to at authorized service engineer for repair, because special
purpose tools are required.
11) In the interest of safety, regular periodic close checks should be carried out on the supply
cord to ensure no damage is evident. Should there be any signs that the cord is damaged in the
slightest degree, the entire appliance should be returned at authorized service engineer.
12) Do not let the cord hang over the edge of a table or counter or touch hot surfaces. Allow
- 6 -