Operation; Commissioning - Rothenberger ROSCOPE mini Instrucciones De Uso

Always replace all batteries at the same time. Only use batteries from one brand and with the identi-
cal capacity.
Remove the batteries from the inspection camera when not using it for a prolonged
period of time. The batteries can corrode and self-discharge during prolonged storage.
Mounting the Mirror, Magnet:
The mirror and the magnet can be mounted to the camera head as auxiliary aids.
Slide one of the auxiliary aids to the stop onto the recess on the camera head as shown in the
figure.
The magnet is only suitable for moving and removing loose, small and light objects.
3.3

Operation

Keep the hand unit and the batteries dry and protect them from direct sun-
light. The camera cable and camera head are waterproof when mounted correctly.
However, the hand unit and the batteries are not protected against water. If they
come into contact with water, there is a risk of electric shock or damage.
Do not subject the inspection camera to extreme temperatures or variations in
temperature. As an example, do not leave it in vehicles for longer periods. In case
of large variations in temperature, allow the inspection camera to adjust to the ambi-
ent temperature before putting it into operation.
Do not use the inspection camera when the lens on the camera head is misty
or fogged-up. Do not switch the inspection camera on until after the moisture
has evaporated. Otherwise, the inspection camera can become damaged.
The switched-on illumination light can become hot during operation. In order to
prevent burns, do not touch the illumination light.
3.4

Commissioning

Switching On and Off:
To switch on the inspection camera, press the On/Off button
on the display for a short time.
To switch off the inspection camera, press the On/Off button
If no button is pressed on the inspection camera for approx. 20 mins, it will automatically switch off to
save the batteries.
Regulating the Illumination Light in the Camera Head:
To brighten the camera image, you can switch on the illumination light in the camera head and adjust
the brightness.
The brightness can be adjusted in 6 stages.
To switch on the camera illumination light and to increase the brightness, press button
edly until the required brightness is reached.
Do not stare into the illumination light and do not direct it at other persons!
The brightness of the light can blind the eyes.
To reduce the brightness and to switch off the camera illumination light, press button
ly until the required brightness is reached or the illumination light is switched off.
Magnifying the Image on the Display (Zoom):
Briefly pressing button
Status Bar:
The status bar is shown on the display for approx. 2 seconds after every button press. It shows:
– the selected magnification
– the selected brightness
– the charging condition of the batteries
– the storage capacity (max 30 pictures)
8
magnifies the image on the display (1.0x, 1.5x, 2.0x).
ENGLISH
. The start screen will be shown
3s. again.
repeat-
repeated-