Publicidad
the seperated ends.
8. Using the same procedure, insert the T-Connector ends containing
the brown and red wires between the center black connectors on the
passenger side tail light housing.
9. Locate a clean accessible mounting location on the vehicle near
the wiring harness ends within reach of the white wire and grounding
eyelet and drill a 7/64" hole.
Caution: Take care not to drill through the body or any
exposed surface.
10. Mount the white wire using the ground screw and eyelet provided.
11. Route the 12 gauge black wire from the battery
compartment under the vehicle along the frame to a
position near the right (passenger) side tail light
housing and the T-Connectors black box (fig. 4).
Secure the wire to the vehicle using cable ties
(included).
Caution: When routing wire through metal or
other sharp surfaces, always utilize an existing
grommet, provide a grommet or insulate the wire from the
hole with silicone rubber.
12. Connect the opposite end of the fuse holder to the black 12 ga.
wire using the yellow butt connector provided.
13. With the fuse removed , attach the 3/8" ring terminal to the
vehicles positive (+) battery terminal (Fig. 5).
Warning: Do not attempt to connect the black power wire to
the vehicle fuse panel or any other accessory wiring. Failure
to connect directly to the vehicle battery could cause vehicle
damage and/or trailer lighting failure.
14. At the rear of the vehicle, Strip 5/16" of
insulation from the black 12 ga. wire and
connect it to the blue wire using the yellow
butt connector on the converter wire.
Fig 4
Fig 5
Publicidad
