Akron Brass 3425 Instrucciones De Instalación, Funcionamiento Y Mantenimiento página 3

The following is intended to provide the basic instructions for installation, operating and maintenance of the Aries monitor . Read and
understand these operating instructions before use .
PRODUCT RATINGS:
Maximum flow : 1250 gpm
Maximum Pressure : 200 psi
The maximum flow of the Aries monitor is 1250 gpm . The center of the waterway is 11 in . from the bottom of the inlet flange . Ensure
these values and an appropriate safety factor are used to determine a proper support structure .
PRODUCT WARNINGS:
WARNING: Insufficient structural support can lead to failure, which has potential to cause an injury .
Therefore, additional structural support at the inlet flange on the vehicle deck may be required .
(Contact Akron Brass Customer Service for assistance . )
WARNING: Charge the unit slowly . Rapid charging may cause a pressure surge which has the potential to cause an injury, or
damage the monitor . Aim the unit in a safe direction before pumping water through it .
Replace the identification tags if they should become worn or damaged .
WARNING: DO NOT exceed the maximum pressure or flow ratings of the monitor .
Exceeding these ratings has the potential to cause an injury or damage the monitor .
WARNING: DO NOT install shutoffs on the outlet of the Aries monitor . Shutoffs increase the potential for pressure surges due
to water hammer, which have the potential to cause an injury or damage the monitor .
Drain the Aries monitor after use to prevent "freeze damage . "
Ensure the thread on the nozzle swivel matches the thread on the monitor outlet . Do not over tighten the nozzle
onto the unit .
1
STYLE 3425 AND 3525 ARIES MONITOR
INSTALLATION, OPERATING, AND MAINTENANCE
INSTRUCTIONS
MATERIAL:
3425: Pyrolite 24 . 7 5 lbs . (11 . 2 kg)
3525: Brass 66 lbs . (30 kg)
104622