Maintenance Instructions - Akron Brass 3425 Instrucciones De Instalación, Funcionamiento Y Mantenimiento

MONITOR ATTACHMENT:
The monitor is to be mounted on the waterway with eight
mounting to a 4 inch flange . When mounting to a three inch flange only four bolts, nuts, and washers are required .
OPERATING INSTRUCTIONS:
The hand wheel and the brake knob are used to control the monitor . To change the horizontal monitor position toward the "RIGHT"
or "LEFT," turn the brake knob counterclockwise until the unit can be easily rotated . Turn the same knob to the right to lock the unit
in the desired horizontal position . To change the vertical monitor position upward or downward, turn the hand wheel clockwise or
counterclockwise until it is aimed in the desired direction .
CAUTIONS:
Your Aries monitor and nozzle should be inspected prior to and after each use to ensure it is in good operating condition . Periodically,
an unanticipated incident occurs where the unit is misused in a manner that is inconsistent with standard operating practices .
A partial list of potential misuses includes:
• Operating above maximum rated pressure or flow.
• Not draining and allowing water to freeze in the unit.
• Prolonged exposure to temperatures above 140ºF, or below -40ºF.
• Operating in a corrosive environment.
• Other misuse that might be unique to your specific environment.
Also, there are many "tell tale" signs that indicate repair is in order, such as:
• A hand wheel that is inoperable or difficult to operate.
• Excessive wear
• Poor discharge performance
• Water leaks.
If any of the above situations are encountered, the Aries should be taken out of service, repaired, and tested by a qualified technician
before placing back in service .

MAINTENANCE INSTRUCTIONS:

• Periodically lubricate the grease fittings with Lubriplate Low-Temp or equivalent. Inject the lubricant until it becomes visible from
the bleeder holes in the center of the swivel plugs .
• Periodically clean grit and dirt from around exterior moving parts.
• Periodically operate all functions of the monitor through it's full travel.
ISO 9001 REGISTERED COMPANY
2
5 /
inch bolts and nuts of grade five minimum, and suitable washers when
8
PHONE: 330 . 2 64 . 5 678 or 800 . 2 28 . 1 161 I FAX: 330 . 2 64 . 2 944 or 800 . 5 31 . 7 335 I akronbrass . c om
WARRANTY AND DISCLAIMER: We warrant Akron Brass products for a period of five (5) years after purchase against defects in materials or workmanship . Akron Brass will repair or replace product which fails to satisfy this
warranty . Repair or replacement shall be at the discretion of Akron Brass . Products must be promptly returned to Akron Brass for warranty service .
We will not be responsible for: wear and tear; any improper installation, use, maintenance or storage; negligence of the owner or user; repair or modification after delivery; damage; failure to follow our instructions or
recommendations; or anything else beyond our control . WE MAKE NO WARRANTIES, EXPRESS OR IMPLIED, OTHER THAN THOSE INCLUDED IN THIS WARRANTY STATEMENT, AND WE DISCLAIM ANY IMPLIED WARRANTY
OF MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE . Further, we will not be responsible for any consequential, incidental or indirect damages (including, but not limited to, any loss of profits) from any cause
whatsoever . No person has authority to change this warranty .
© Akron Brass Company . 2011 All rights reserved . No portion of this can be reproduced without the express written consent of
REvISED: 8/12
Akron Brass Company .