Covers; Flywheel/Pillow Block Bearings - LeMond Fitness RevMaster Manual De Usuario

PARTS REMOVAL AND REPLACEMENT

COVERS

Front Cover
1. Using the screwdriver remove the four screws that secure the
cover to the frame and back cover.
2. Slide the cover over the right pedal crank and remove the
cover from the frame.
Back Cover
1. Using the screwdriver remove the five screws that secure the
cover to the frame and the front cover.
2. Remove the front cover.
3. Remove the remaining screws that secure the back to the frame.
Slide the back cover over the right pedal crank and remove the cover
from the frame.

FLYWHEEL/PILLOW BLOCK BEARINGS

Note: The flywheel weighs 47 pounds; it is recommended to have an
assistant help you with the replacement of the flywheel.
1. Remove the belt.
2. Using a 5 mm allen wrench
remove the two mounting bolts
that secure each of the pillow
block bearings on either side of
the flywheel to the frame.
3. Have an assistant help you lift
the flywheel up and remove the
flywheel from the frame.
4. Place the flywheel on a padded
surface with the pulley side
facing up.
Note: Lay the flywheel down on a padded surface. Any surface
damage (nicks, dings, etc.) to the flywheel will effect perfor-
mance
Pillowblock Bearing
Flywheel
Page 19