Seat; Seat Slider - LeMond Fitness RevMaster Manual De Usuario

PARTS REMOVAL AND REPLACEMENT
Right Crank Arm
1. Remove the front cover and belt.
2. Using an 8-mm wrench, remove the crank arm bolt.
3. Thread a bicycle crank arm removal tool onto the crank arm shaft .
4. As you tighten the crank arm removal tool on the shaft, the crank arm
will pull off the crank arm shaft. Remove the crank arm form the
frame.
5. Apply a thin coat of grease on the bottom bracket spindle and align
the new crank arm 180° from the left crank arm and push the crank
arm on to the crank arm shaft.
6. Apply a thin coat of grease on the crank arm bolt. Install the crank
arm bolt and tighten to secure the crank arm. Rotate the pedals a few
revolutions and then tighten the crank arm bolt again to ensure that
the crank arm is tight.
7. Reinstall the belt and front cover.

SEAT

1. Use an adjustable wrench to loosen each nut on either side of the
seat.
2. Lift the seat off the seat slider.
3. Position the new seat on the seat slider, level the seat, and evenly
tighten each seat nut.
Note: Ensure that the nuts on the seat clamp are fully tight-
ened to prevent the seat from moving during use.

SEAT SLIDER

1. Rotate the seat adjustment handle counterclockwise and unscrew the
handle from the seat.
2. Lift the seat slider off the seat post and remove it from the frame.
3. Align the adjustment groove in the new seat slider with the adjust-
ment groove in the seat post.
4. Insert the seat adjustment handle into one of two position holes in the
seat slider. Do not tighten.
5. Position the seat in the desired location and rotate the seat adjustment
Page 22