General Instructions; Safety Instructions - Grammer PRIMO M Manual De Instrucciones

General instructions

The operating instructions must be read in full before use.
The operating instructions must be kept in the vehicle and always be at hand.
The driver's seat may only be fitted, serviced and repaired by specialist personnel,
in accordance with national regulations and the vehicle manufacturer's fitting instructions.
The national fitting regulations can be obtained from GRAMMER or from agencies of the
company, or from the vehicle manufacturer.
A correctly functioning and individually adjusted driver's seat is essential to your health.
Take adequate care of your seat and have it serviced regularly to ensure that it functions
correctly.
The functional checks are to be carried out at least as regularly as vehicle
services (see maintenance plan for vehicle).
These operating instructions should always be kept with the driver's seat. If the seat is
passed on to a third party, it must be accompanied by the relevant operating instructions.

Safety instructions

If you need to connect cables to the vehicle supply network, strictly observe the following
instructions:
Before you connect a seat switch or a seat heater, you must obtain the relevant electrical
data for the respective vehicle with reference to voltage, protection and the kind of
connections from the manufacturer, from GRAMMER or the company's agencies.
For safety reasons, the installation and connection to the vehicle supply network must be
carried out by authorized specialist personnel only.
The seat connections must be protected independently of other vehicle components.
Seat heater
12V DC 10A
24V DC 10A
48V DC 10A
Notes concerning seat switch: Minimum and maximum current carrying capacity for
purely resistive load.
In case of inductive or capacitive load, the manufacturer must install a protective circuit
breaker for the consumers in the vehicle. If there are any uncertainties, please ask the
vehicle manufacturer before making connections.
Driver's seats that have been adjusted incorrectly have a smaller moving area. To prevent
damage to the driver's back and to the seat, the seat must be adjusted for the driver's
weight before use and before every change of driver. To prevent injury, no objects
should be placed within the moving area of the driver's seat.
18
Seat switch – Current carrying capacity
12V DC
250V DC
10mA (min.)
5A (max.)
GB