Mopar 82212789AB Instrucciones De Montaje página 4

4
16. Release the clip (3) and position the fuse box assem­
bly (2) down.
17. Disconnect the electrical connectors (4) from the fuse
box (2).
18. Push the fuse box (2) down and inward toward the
floor. The top of the fuse box will roll back and release
from the track.
NOTE: Remember which connectors are A and D for
later installation of fog lamp terminals.
19. Disconnect the electrical connectors from the Body
Control Module (BCM) (1).
20. Remove the two fasteners (4) at the bottom of the
BCM.
21. Pull the BCM away from the side bulk head and down
to remove.
22. Raise and support the vehicle.
23. Remove the RF wheel.
24. Remove the front lower close out panel (3) as follows:
• Remove the side push­in retainers (1). Repeat for
the other side.
• Remove the push­in retainers (4) to the cross
frame.
• Remove the push­in retainers (2) to the lower fas­
cia.
• Remove the front lower close out panel (3).
Feb 11, 2011
www.mopar.com
K6861239