Troubleshooting - STEINEL 170 Serie Manual Del Usuario

Serie 170-190_10spr.qxd

Troubleshooting

Malfunction
SensorLight without power
SensorLight will not switch ON
SensorLight will not switch OFF
SensorLight switches ON when it
should not
SensorLight reach changed
LED on all the time although
permanent light not selected
Functional Warranty
This STEINEL product has been manufactured with
great care, tested for proper operation and safety in
accordance with applicable regulations and then sub-
jected to random sample inspection. STEINEL guar-
antees that it is perfect condition and proper working
order. The warranty period is 36 months, starting on
the date of sale to the consumer. We will remedy
defects caused by material flaws or manufacturing
faults. The warranty will be met by repair or replace-
ment of defective parts at our own discretion. The
warranty shall not cover damage to wear parts, dam-
age or defects caused by improper treatment or
maintenance. Further consequential damage to other
objects shall be excluded.
31.07.2008 12:35 Uhr
Cause
I Fuse faulty, not switched ON,
break in wiring
I Short circuit
I Twilight control set to night-time
mode during daytime operation
I Bulb faulty
I Power switch OFF
I Fuse faulty
I Detection zone not properly
targeted
I Internal electrical fuse has been
activated (LED on all the time)
I Continuous movement in the
detection zone
I Wind is moving trees and
bushes in the detection zone
I Cars in the street are being
detected
I Sunlight shining on the lens
I Sudden temperature changes
due to weather (wind, rain, snow)
or air expelled from fans, open
windows
I Lens not pressed firmly enough
into groove
I Differing ambient temperatures
I Internal fuse activated
Claims under warranty shall only be accepted if the
product is sent fully assembled and well packed
complete with receipt or invoice (date of purchase and
dealer's stamp) to the appropriate service centre or
handed in to the dealer within the first 6 months.
Repair service:
Our Customer Service Department will
repair faults not covered by warranty
or occurring after the warranty has
expired. Please send the product well
packed to your nearest Service Centre.
- 11 -
Seite 12
Remedy
I Renew fuse, switch ON mains
switch, check wiring with
voltage tester
I Check connections
I Re-adjust (button
I Replace light bulb
I Switch on
I Replace fuse, check
connection if necessary
I Readjust
I Switch SensorLight OFF and
back on again after 5 sec.
I Check detection zone and
re-adjust if necessary
I Change detection zone
I Change detection zone
I Mount sensor in a protected
place or change detection zone
I Change detection zone, change
site of installation
I Press lens into groove
I Use shrouds to define detection
zone precisely
I Switch SensorLight OFF and
back ON again after 5 sec.
)
36