Grizzly ELS 2614 E Manual De Instrucciones página 119

- transporting it or leaving it unat-
tended;
- when you are checking the device,
cleaning it or removing blockages;
- when you are carrying out cleaning
or maintenance work or replacing
accessories;
- when the power or extension cable
is damaged; after contact with for-
eign bodies or in case of abnormal
vibration;
• Do not attempt to repair the appliance
yourself unless you have specific train-
ing to do so. Leave any work not listed
in this manual to our Service Centre.
• Do not intake any moist or wet material
or any liquids.
• Do not use the device in closed or
badly ventilated rooms. Do not use
the device near inflammable liquids or
gases. In case of non-observance of
these directions, danger of fire or ex-
plosion exists.
• Keep the device in a dry location and
out of reach of children.
• Handle the unit with care. Clean the
ventilation slits regularly; keep to the
maintenance instructions.
• Keep all cooling air inlets clear of dirt.
Electrical safety:
• Make sure that the mains voltage is
compatible with the information of the
label.
• Connect the device, as far as possible,
only to a plug socket with a ground-
fault circuit interrupter (g.f.c.i switch),
with a rated residual current at not
more than 30 mA.
• Check the device and the power cable
with plug for damage before every use.
Avoid bodily contact with grounded
parts (e.g. metal fences, metal post).
• The coupling of the extension cord
must be protected against splashed
water, it must consist of rubber or be
surrounded by rubber. Employ only
extension cords which are stipulated
for use in the open air and are marked
accordingly. The flexible lead cross-
section of the extension cord must at
least 2.5 mm . Always roll out the cable
2
drum completely before use. Check
the cable for damage.
• Keep the cable away from the field of
action and basically play it out behind
the operator.
• Use the tension relief provided for the
fixing of the extension cord.
• Do not carry the device by the cable.
Do not use the cable to pull out the
plug from the plug socket. Protect
the cable against heat, oil and sharp
edges.
• Damaged cables, coupling and plugs
or connecting leads not correspond-
ing to specifications, must not be em-
ployed. Remove the plug immediately
from the plug socket in case of dam-
age to the mains cable.
Do not touch the mains power supply
cable under any circumstances until
you have pulled the plug out of the
mains socket.
• If the power cable for this equipment
is damaged, it must be replaced by
the manufacturer, a customer service
agent of the same or a similarly quali-
fied person in order to prevent haz-
ards.
• Do not use the appliance if the on/off
switch does not work properly. Always
have a damaged switch repaired by
our Service Centre.
• Do not overload your device. Work
GB
119