Error Messages - Beninca MATRIX Manual De Instrucciones

In the event of malfunctions, by pressing key + or - the status of all inputs (limit switches, control and safety) can be displayed. One
segment of the display is linked to each input. In the event of failure it switches on according to the following scheme.
N.C. inputs are represented by the vertical segments. N.O. inputs are represented by the horizontal segments.
For example, with the leaf
completely closed the display
is as follows:
The control unit checks the correct operation of the safety devices. In case of failure, the following messages may appear on the
display:
Error, check photocells at PHOT O input.
ERR1
Error, check photocells at PHOT C input.
ERR2
Error, ENCODER
ERR3
Error, TRIAC
ERR4
Let us suppose it is necessary to:
- set an automatic closing time (TCA) of 100s
- activate pre-blinking
Perform the operations described below step by step:
Step Press Display
1
PAR
2
TCA
3
040
4
100
5
PRG
TCA
6
PAR
7
Log
8
TCA
9
Pre
10
OFF
11
12
PRG
Pre
13
PAR
14
���
���� �
the moment an Open impulse
is given:
Example of programming
First menu
First function of the first menu
Value currently set for the function selected
Set the desired value with the <+> and <-> keys
The value is programmed
When programming has been made, the display goes to the function just set
Press <+> and <-> simultaneously to go to the higher menu
Second menu
First function of the second menu
Press <-> several times to select PRE logic
Value currently set for the function selected
Set the desired value with the <+> and <-> keys
ON
The value is programmed
When programming has been made, the display goes to the function just set
Press <+> and <-> simultaneously to go to the higher menu and quit programming or wait
30s.
Diagnostics
���
���� ��� ���� �����
����
���� �
���
during the opening phase:

Error messages

Notes
with the leaf completely open: