Black and Decker BCASK8967D2 Manual De Instrucciones página 17

Chargers
Use your BLACK+DECKER charger only to charge the
u
battery in the tool with which it was supplied. Other batter-
ies could burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
u
Have defective cords replaced immediately.
u
Do not expose the charger to water.
u
Do not open the charger.
u
$ Do not probe the charger.
u
The charger is intended for indoor use only.
+
Read the instruction manual before use.
Electrical safety
#
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on
the rating plate. Never attempt to replace the
charger unit with a regular mains plug.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Features
This appliance includes some or all of the following features.
1. Power head
2. Main handle
3. Bail handle
4. On/off switch
5. Lock off switch
6. Blower attachment
7. Blower release button
8. Blower tube
9. Chainsaw attachment
10. Chainsaw attachment release button
11. Kick back guard
12. Kick back guard release button
13. Guide bar
14. Saw chain
15. Guide bar cover
16. Hedge trimmer attachment
17. Hedge trimmer release button
18. Hedge trimmer blade
19. Guard
20. Extension pole
21. Pole grip
22. Extension pole release button
23. String trimmer attachment
24. String trimmer attachment release button
(Original instructions)
25. Guard
26. Spool housing
27. Spool cap
28. Spool cap release tab
29. Battery
Charging a battery (fig. A1)
BLACK+DECKER chargers are designed to charge
BLACK+DECKER battery packs.
Plug the charger (30) into an appropriate outlet before
u
inserting a battery pack (29).
Insert the battery pack (29) into the charger, making sure
u
the battery pack is fully seated in the battery slots (Figure
A1).
The LED (30a) will flash indicating that the
battery is being charged.
The completion of charge is indicated by the
LED remaining on continuously. The pack is
fully charged and may be used at this time or
left in the charger.
Recharge discharged batteries as soon as possible after
u
use or battery life may be greatly diminished.
For longest battery life, do not discharge batteries fully.
It is recommended that the batteries be recharged after
each use.
Charger diagnostics (fig. A2)
This charger is designed to detect certain problems that can
arise with the battery packs or the power source. Problems
are indicated by one LED flashing in different patterns.
Bad battery
The charger can detect a weak or damaged
battery. The LED flashes in the pattern indi-
cated on the label. If you see this bad battery
blink pattern, do not continue to charge the battery. Return it
to a service center or a collection site for ecycling.
Hot/cold pack delay
When the charger detects a battery that
is excessively hot or excessively cold, it
automatically starts a Hot/Cold Pack Delay,
suspending charging until the battery has normalized. After
this happens, the charger automatically switches to the Pack
Charging mode. This feature ensures maximum battery life.
The light flashes in the pattern indicated on the label.
Leaving the battery in the charger
The charger and battery pack can be left connected with
the LED glowing indefinitely. The charger will keep the
battery pack fresh and fully charged. This charger features
an automatic tune-up mode which equals or balances the
ENGLISH
17 17