Protecting The Environment - Black and Decker GLC2000 Manual De Instrucciones

E N G L I S H
Before performing any maintenance on
the tool, remove the battery from the tool.
Unplug the charger before cleaning it.
Regularly clean the cutting line and spool
using a soft brush or dry cloth.
Regularly use a blunt scraper to remove grass
and dirt from the underneath of the guard.
Regularly clean the ventilation slots in your tool
using a soft brush or dry cloth.
Regularly clean the motor housing using a
damp cloth. Do not use any abrasive or
solvent-based cleaner.
Storage
When the tool will not be used for several months,
ideally leave the battery connected to the charger.
Otherwise proceed as follows:
Fully charge the battery.
Remove the battery from the tool.
Store the tool and battery in a secure and dry
location. The storage temperature must always
remain in the range of +5 °C to +40 °C.
Place the battery on a level surface.
Before using the tool after prolonged storage,
fully charge the battery again.
TROUBLESHOOTING
If your tool seems not to operate properly, follow
the instructions below. If this does not solve the
problem, please contact your local Black & Decker
repair agent.
Before proceeding, remove the battery
from the tool.
Tool runs slowly
Check that the spool housing can rotate freely.
Carefully clean it if necessary.
Check that the cutting line does not protrude
more than 10-12 cm from the spool housing.
If it does, cut it off so that it just reaches the
line trimming blade.
Connect the battery to the charger and plug
the charger in. Wait until the green indicator
light lights up to ensure that the battery is fully
charged.
14
Automatic line feed does not work
Keep the tabs depressed and remove the
spool cover from the spool.
Lift the spool approx. 6 mm and pull the
cutting line until it protrudes 10-12 cm from
the housing. If insufficient cutting line is left on
the spool, install a new spool of cutting line as
instructed above.
Push the spool back into place and rotate it
slightly until it is seated.
Align the tabs on the spool cover with the
holes in the housing.
Push the cover onto the housing until it snaps
securely into place.
If the cutting line protrudes beyond the
trimming blade, cut it off so that it just reaches
the blade.
If the automatic line feed still does not work,
try the following suggestions:
Carefully clean the spool housing.
Remove the spool and check if the lever can
move freely.
Remove the spool and unwind the cutting line,
then wind it on neatly again as described
above. Replace the spool as instructed.
Spool is jammed
Keep the tabs depressed and remove the
spool cover from the spool.
Carefully clean the spool housing.
Push the cover onto the housing until it snaps
securely into place.

PROTECTING THE ENVIRONMENT

Tools
Should you find one day that your tool
needs replacement, or if it is of no further
use to you, think of the protection of the
environment. Black & Decker repair agents
will accept old Black & Decker tools and
ensure that they are disposed of in an
environmentally safe way.