Commissioning; Alignment; Sensing Range - SICK GSE6L Instrucciones De Operación

-Px1xx
-Px2xx
-Px3xx
-Px4xx
D.ON, PNP: Q (≤ 100 mA)
-Nx1xx
-Nx2xx
-Nx5xx
-Nx6xx
L.ON, NPN Open Collector Q (≤ 100 mA)
-Nx1xx
-Nx2xx
-Nx3xx
-Nx4xx
D.ON, NPN Open Collector Q (≤ 100 mA)
7

Commissioning

7.1

Alignment

7.2

Sensing range

8025390.1AR6 / 21.02.2021 | SICK
Subject to change without notice
Align the sender with the receiver. Select the position so that the red emitted light beam
hits the receiver. Tip: Use white paper or a reflector as an alignment aid. The sender
must have a clear view of the receiver, with no object in the path of the beam [see
figure 3]. You must ensure that the optical openings (front screen) of the sensors are
completely clear.
Figure 3: Alignment
Observe the application conditions: Adjust the distance between the sender and the
receiver according to the corresponding diagram [see
operating reserve).
When mounting through beam photoelectric sensors adjacent to each other, alternate
the sender (GS6L) and receiver (GE6L) arrangement every other pair. Also ensure
that there is sufficient distance between pairs based on the sender (GS6L) light spot
diameter. By doing this, mutual interference can be prevented [see
Use table 3 to check the function. If the switching output fails to behave in accordance
with table 3, check the application conditions.
+ (L+)
Q
‒ (M)
+ (L+) + (L+)
Q Q
‒ (M) ‒ (M)
+ (L+)
Q
‒ (M)
figure
COMMISSIONING
+ (L+)
Q
‒ (M)
+ (L+)
Q
‒ (M)
+ (L+) + (L+)
Q
Q
‒ (M) ‒ (M)
4] (x = sensing range, y =
figure 1].
7
9