Electrical Installation - SICK GSE6L Instrucciones De Operación

6

Electrical installation

8025390.1AR6 / 21.02.2021 | SICK
Subject to change without notice
NOTE
When mounting through beam photoelectric sensors adjacent to each other, alternate
the sender (GS6L) and receiver (GE6L) arrangement every other pair. Also ensure
that there is sufficient distance between pairs based on the sender (GS6L) light spot
diameter. Refer to figure 1
Sender (GS)
Receiver (GE)
Sender (GS)
Figure 1: Arrangement of several through-beam photoelectric sensors
Diameter in mm (inch)
Ø 3.5 Ø 70 Ø 90 Ø 120
(0.14) (2.76) (3.54) (4.72)
1 12 30
(3.28) (39.37) (98.43) (131.23)
Distance in m (feet)
Figure 2: GSE6L
The sensors must be connected in a voltage-free state (U
tion must be observed depending on the connection type:
– Plug connection: pin assignment
– Cable: wire color
Only apply voltage/switch on the voltage supply (U
tions have been established.
Explanation of connection terminology:
BN = Brown
WH = White
BU = Blue
BK = Black
n. c. = no connection
Q = switching output 1
Q = switching output 2
L+ = supply voltage (Uv)
M = common
L.ON = light operate
and figure 2.
40
V
ELECTRICAL INSTALLATION
Receiver (GE)
Sender (GS)
Receiver (GE)
= 0 V). The following informa‐
V
> 0 V) once all electrical connec‐
6
7