Optional Accessories; Protecting The Environment - DeWalt DC212 Traducido De Las Instrucciones Originales

DC213 - Chipping (fi g. A)
• Set the mode selector switch (3) to the
"hammering only" position.
• Insert the appropriate chisel and check if it is
properly locked.
• Adjust the side handle (9) as required.
• Switch on the tool and start working.
It may be necessary to briefly run the motor after
having changed from chiselling to rotary modes in
order to align the gears.
WARNING:
• Do not use this tool to mix or pump
easily combustible or explosive fluids
(benzine, alcohol, etc.).
• Do not mix or stir inflammable liquids
labelled accordingly.
MAINTENANCE
Your D WALT power tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular
cleaning.
• This machine is not user-serviceable. Take the
tool to an authorised D WALT repair agent after
E
approximately 40 hours of use. If problems
occur before this time contact an authorised
D WALT repair agent.
E
• The charger is not serviceable. There are no
serviceable parts inside the charger.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
WARNING: Never use solvents or
other harsh chemicals for cleaning the
non-metallic parts of the tool. These
chemicals may weaken the materials
used in these parts. Use a cloth
dampened only with water and mild
soap. Never let any liquid get inside the
tool; never immerse any part of the tool
into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect
the charger from the AC outlet before
cleaning. Dirt and grease may be
removed from the exterior of the charger
using a cloth or soft non-metallic brush.
Do not use water or any cleaning
solutions.

Optional Accessories

WARNING: Since accessories, other
than those offered by D
not been tested with this product, use
of such accessories with this tool could
be hazardous. To reduce the risk of
injury, only D WALT, recommended
E
accessories should be used with this
product.
Various types of SDS Plus ® drill bits and chisels are
available as an option.
Accessories and attachments used must be
regularly lubricated around the SDS Plus
Consult your dealer for further information on the
appropriate accessories.

Protecting the Environment

Separate collection. This product must
not be disposed of with normal
household waste.
Should you find one day that your D
needs replacement, or if it is of no further use to
you, do not dispose of it with household waste.
Make this product available for separate collection.
Separate collection of used products
and packaging allows materials to be
recycled and used again. Re-use of
recycled materials helps prevent
environmental pollution and reduces the
demand for raw materials.
Local regulations may provide for separate collection
of electrical products from the household, at
municipal waste sites or by the retailer when you
purchase a new product.
D WALT provides a facility for the collection and
E
recycling of D WALT products once they have
E
EN G LI SH
WALT, have
E
® fitment.
WALT product
E
41