Additional Safety Information; Batteries And Chargers - Craftsman Quickwind 20V Max Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

DO NOT allow any liquid to get inside it. If appliance does
get wet, allow to dry for a minimum of 48 hours.
DO NOT clean with a pressure washer.
DO NOT store the appliance on or adjacent to fertilizers
or chemicals.
DO NOT charge appliance in rain, or in wet locations.

Additional Safety Information


WARNING:
ALWAYS use safety glasses.
Everyday eyeglasses are NOT safety glasses. Also use
face or dust mask if operation is dusty. ALWAYS WEAR
CERTIFIED SAFETY EQUIPMENT:
ANSI Z87.1 eye protection (CAN/CSA Z94.3),
ANSI S12.6 (S3.19) hearing protection,
NIOSH/OSHA/MSHA respiratory protection.

WARNING:
Some dust contains
chemicals known to State of California to cause
cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
compounds in fertilizers,
compounds in insecticides, herbicides
and pesticides,
arsenic and chromium from chemically
treated lumber.
To reduce your exposure to these chemicals,
wear approved safety equipment such as dust
masks that are specially designed to filter out
microscopic particles.
Avoid prolonged contact with dust from power
sanding, sawing, grinding, drilling, and other
construction activities. Wear protective clothing and
wash exposed areas with soap and water. Allowing
dust to get into your mouth, eyes, or lay on the skin may
promote absorption of harmful chemicals.

WARNING:
Use of this tool can generate
and/or disperse dust, which may cause serious
and permanent respiratory or other injury. Always
use NIOSH/OSHA approved respiratory protection
appropriate for the dust exposure. Direct particles
away from face and body.

WARNING:
Always wear proper
personal hearing protection that conforms
to ANSI S12.6 (S3.19) during use. Under some
conditions and duration of use, noise from this
product may contribute to hearing loss.

CAUTION:
When not in use, place tool
on its side on a stable surface where it will not
All manuals and user guides at all-guides.com
The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ......................... volts
Hz ....................... hertz
min ..................... minutes
.../min .............. per minute
BPM .................... beats per minute
IPM ..................... impacts per minute
RPM .................... revolutions per
sfpm ................... surface feet per
SPM .................... strokes per minute
OPM .................... oscillations per
A ......................... amperes
W ........................ watts

BATTERIES AND CHARGERS

The battery pack is not fully charged out of the carton.
Before using the battery pack and charger, read the
safety instructions below and then follow charging
procedures outlined. When ordering replacement battery
packs, be sure to include the catalog number and voltage.
Important Safety Instructions for All
Battery Packs

cause a tripping or falling hazard. Some tools with
a large battery pack will stand upright but may be
easily knocked over.
Air vents often cover moving parts and should be
avoided. Loose clothes, jewelry or long hair can be
caught in moving parts.
or AC/DC .... alternating or
...................... Class II
or DC ...... direct current
...................... Class I Construction
n o ....................... no load speed
(grounded)
n ......................... rated speed
...................... earthing terminal
..................... safety alert symbol
..................... visible radiation
..................... avoid staring at
minute
..................... wear respiratory
minute
..................... wear eye
minute
..................... wear hearing
..................... read all
or AC ........... alternating current
IPXX .................... IP symbol
READ ALL INSTRUCTIONS
WARNING:
Read all safety warnings,
instructions, and cautionary markings for the
battery pack, charger and product. Failure to
follow the warnings and instructions may result
in electric shock, fire and/or serious injury.
Do not charge or use the battery pack in explosive
atmospheres, such as in the presence of flammable
liquids, gases or dust. Inserting or removing the battery
pack from the charger may ignite the dust or fumes.
When battery pack is not in use, keep it away from
other metal objects, like paper clips, coins, keys,
nails, screws, or other small metal objects, that can
make a connection from one terminal to another.
English
direct current
Construction
(double insulated)
light
protection
protection
protection
documentation
3

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Cmcst920

Tabla de contenido