Publicidad
Idiomas disponibles
Idiomas disponibles
5.
Install Fasteners– Install the supplied fasteners as shown in figure 1. Items
k
and
will be installed onto the existing weld nuts. Item
inserted into the access hole, to the attachment hole and install items
n
.
7.
Raise Exhaust- Raise exhaust and reattach hangers. Note: Reconnect the
electrical wire if removed in step 3.
©2018 Horizon Global™ Corp. - Printed in Mexico
j
6.
Torque Fasteners– Torque all 1/2"-13 GR5 fasteners to 50 Lb-Ft (68 n-m) and all
10mm-1.5 CL10.9 fasteners to 38 Lb-Ft (52 n-m)
o
will be formed a
Proper torque is needed to keep the hitch secure to the vehicle when towing.
l m
and
8.
Trim Underbody Panel- (If installed) Trim the underbody panel (SEE FIGURE 2).
Using the holes for the 10mm fasteners (not centered) measure 4 5/16" from the
passenger side attachment hole and mark the center line. Trim a 5 1/2"x 6" section
in the center/rear of the panel. Then Trim a 2" section 20 5/16" from the center line
to the passenger side leaving a 1" tab in the rear to reattach to the fascia. Then trim
a 2" section 17 1/4" from the center line to the driver side leaving a 1" tab in the
rear to reattach the fascia. Then install.
Leave 1" Tab
Sheet 5 of 15
5 1/2"
5
1/2"
6"
4 5/16"
17 1/4"
2"
C L
36660NP
Leave 1" Tab
2"
20 5/16"
02-09-18
Rev. A
Publicidad
