Controls And Input Connections; Switching On; Using The Remote Control; Using The Controls And Connections - Toshiba Regza XV50 DIGITAL Serie Manual De Instrucciones

SETTING UP

Controls and input connections

A wide variety of external equipment can be connected to the input sockets on the side of the television.
Whilst all the necessary adjustments and controls for the television are made using the remote control, the
buttons on the television may be used for some functions.
POWER switch
Input 3 (side) will take
priority over EXT3 (back) if both
connections are used at the
same time.

Switching on

If the RED LED is unlit check that the mains plug is connected
to the power supply and press the
left side of the television to switch the television on. If the
picture does not appear press
take a few moments.
To put the television into Standby press
control, the GREEN active standby LED will appear (see
'Software Upgrade' section) next to the RED for a few moments
then disappear. To view the television press
picture may take a few seconds to appear.

Using the remote control

Press M on the remote control to see the menus.
In digital mode the menu bar at the top of the screens will
show three different topics shown in symbols. As each symbol
C
is selected by pressing the
control, its respective options will appear below.
In analogue mode the menu appears as a list of six topics. As
each symbol is selected by pressing
ring on the remote control, its respective options will appear
below.
GREEN LED - Active standby
(digital only)
!
(POWER) button on the
1
on the remote control, it may
1
on the remote
1
again. The
c
or button on the remote
C c
or on the navigation
RED LED – Standby
GREEN LED – Power on
To use the options, press
move up and down through them and Q,
required choice. Follow the on-screen instructions. The
functions of each menu are described in detail throughout the
manual.

Using the controls and connections

To alter the volume press –
To alter the programme position press
I i
Press MENU and , ,
options.
Press MENU twice to finish.
An S-video cable provides better picture performance than a
composite video cable. If you connect an S-video cable to
EXT3, be sure to disconnect the standard (composite) video
cable or the picture performance will be unacceptable.
To select the external input, press
input source is selected as described on page 35.
Please always refer to the owner's manual of the equipment to
be connected for full details.
12
Standby
COMMON INTERFACE
The Common Interface is for a
Conditional Access Module
(CAM).
Contact a service provider.
HDMI3
INPUT
INPUT 3
(EXT3)
B b
and on the remote control to
C c
or to select the
2
+.
b p B
.
U u
or to control the sound and picture
o
until the appropriate