Forch AC 71 Manual Del Usuario página 91

CONTROL ELEMENTS AND DISPLAY
FRONT
Potentiometer (2)
controls the cutting current
Digital display (3)
Displays the regulated cutting current in amperes. By pressing the button to release steam (B),
this shows the current air pressure value in bar.
Control panel (4)
Control display for air pressure setting showing it is either correct or too high or too low
respectively
Air pressure controller (5)
adjust the pressure of the air supply
Jack for earth cable (6)
Texas connection jack 50 mm² / 13 mm
Plasma cutting burner connection (7)
10 Pin Trafimector central connection
®
REAR
ON/OFF switch (1)
in position (I) the machine is switched on, in position (O) all functions are switched off
Mains cable output (8)
CNC interface (9)
14 pin AMP connection
Compressed air connection (10)