AirPro Progress Lighting P250062 Manual De Instalación página 11

Blade Balancing
All blades are grouped by weight. The fan may
wobble even though the blades are weighed
equally.
The following procedure should correct most fan
wobbling problems. Check after each step.
1. Check that all blade and blade arm screws are
secure.
2. Most fan wobbling problems are caused when
blade levels are unequal. Check this level by
selecting a point on the ceiling above the tip of
one of the blades. Measure this distance as
shown in Figure 14. Rotate the fan until the
next blade is positioned for measurement.
Repeat for each blade. The distance deviation
should be equal within 1/8".
3. Use the enclosed Blade Balancing Kit if the
blade wobble is still noticeable.
4. If the blade wobble is still noticeable,
interchanging two adjacent (side by side)
blades can redistribute the weight and possibly
result in smoother operation.
WARNING
TO REDUCE THE RISK OF PERSONAL
INJURY, DO NOT BEND THE BLADE
HOLDERS WHILE INSTALLING, BALANCING
THE BLADES, OR CLEANING THE FAN. DO
NOT INSERT FOREIGN OBJECTS BETWEEN
ROTATING FAN BLADES.
Touching
ceiling
Figure 14
Installing the Light Kit
and Shatterproof Cover
Note: Before continuing installation, confirm that
the power is still turned off at the main circuit
breaker or by removing the the circuit fuse.
Turning the power off using a wall switch is not
sufficient to prevent electrical stock.
Step 1. Hold the light kit close to the switch
housing and securely attach the 2-pin connectors.
Step 2. Tuck the connections neatly into the light
kit. Align three round holes on the light kit and
switch housing. Securely tighten with 3 screws
(Fig.15)
Step 3. Secure the Shatterproof Cover to the switch
housing by twisting in a clockwise direction. Do
not over-tighten(Fig.16).
Figure 15
Figure 16
Switch
housing
Shatterproof
Cover
8.