Installing The Blades - AirPro Progress Lighting P250062 Manual De Instalación

WARNING
FAILURE TO PROPERLY INSTALL
LOCKING PIN AS NOTED IN STEP 5
COULD RESULT IN FAN LOOSENING AND
POSSIBLY FALLING.

Installing the Blades

Step 1. Attach the blades to the fan motor
assembly using blade up-screws as shown in
Figure 6. Start a screw into the blade, do not
tighten. Repeat for the remaining screw and
washer. Repeat these steps for the remaining
blades.
Step 2. Attach the blade down - screws as
shown in Figure 7. Start a screw into the
blade, do not tighten. Repeat for the
remaining screw. Repeat these steps for the
remaining blades.
5.
Blade up - screw
The top of
the motor
Fan motor assembly
Figure 6
Blade down-
screw
The bottom of the motor
Figure 7
Set screws
6to9in
Downrod
Canopy
Canopy
cover
Coupling
cover
Lock pin
Figure 8
Fan Motor Assembly
Step 3. Remove the hanger pin, lock pin and
set screws from the top of the motor
assembly. (Fig. 8)
Step 4. Route the wires exiting from the top
of the fan motor through the coupling cover,
canopy cover and canopy and then through
the ball / downrod. (Fig. 8)
Step 5. Align the holes at the bottom of the
downrod with the holes in the collar on top of the
motor housing (Fig. 8). Carefully insert the hanger
pin through the holes in the collar and downrod. Be
careful not to jam the pin against the wiring inside
the downrod. Insert the locking pin through the hole
near the end of the hanger pin until it snaps into its
locked position, and tighten set screws as noted in
the circle inset of Fig 8. Cut off excess fixture wires
leaving approximately 6 to 9 inches above top of
hanger ball/downrod assembly.
Hanger pin
Blade