Publicidad
1
90°
•
UK
User guide
How can you remove the visor set ?
- The visor must be closed.
- Start with one of the visor's sides.
- Press the plate's bolt (1) with your finger and turn the locking washer (2) by 90°,
in the same way as the arrow on the washer (A).
- The notch indicated on the washer should then be in front of the line (B).
- The whole set should then come off from the plate.
- Process in the same way for the other side.
- You have then removed the visor set (C).
How can you fix the peak set ?
WARNING : The peak is always fixed to the locking washers and cannot be removed from them (D).
- Place the peak set as shown on the picture (E).
- Both sides must be placed on the plates at the same time (E).
- The locking washer's lugs must be placed properly in the hole of the plate.
- Check that the notches indicated on the washers are right in front of the line indicated
on the plates which are fixed on the helmet (F).
- As you press slightly on both washers, turn the peak set by 90° until you hear a "clic"
sound on both sides to lock the system (G).
- The peak is then in a horizontal position compared with the edge of the shell (G).
- You have then fixed the peak set.
H
H (1)
A
2
OK
•
I
OK
B
E
How can you remove the peak set ?
- Start with one of the peak's sides.
- Press the plate's bolt with your finger (H1) to pivot it downward.
- As you keep pressing the peak, press the opposite plate's bolt with your finger (I) to pivot it
C
downward as well.
- The notch indicated on the washers should then be in front of the lines (J).
- On a lower position, the peak set can then be removed from the plates (J).
- You have then removed the peak set (K).
How can you replace the visor set ?
- Start with one of the visor's sides.
- Check that the notch indicated on the washer is right in front of the line indicated on the plate
D K
which is fixed on the helmet (L).
- The washer's lugs are then placed properly in the holes of the plate.
- Turn the washer by 90° in the opposite direction than the arrow (M) until you hear a "clic" sound,
meaning that the system is locked.
- Process in the same way for the other side.
- You have then replaced the visor set.
- Check that the visor works properly.
J
L
OK
F
OK
M
CLIC
90°
G
CLIC
CLIC
OK
Publicidad
