EGAmaster 79760 Manual De Instrucciones página 50

5. Adjust the gear according to the required application (see fig. 5.1 respectively fig. 5.2).
- Gear 1: for cutting
- Gear 2: for bevelling
Changing gears is done when the machine is stopped. Turn the shaft with the single head
wrench AF 17 and put the lever into the required position (disconnect machine from hydraulic
line before).
6. Connect the hydraulic supply and the cooling water supply (see fig. 6.1 respectively fig.
6.2).
Hydraulic connection
7. Place the feeding pipe. Start the machine (see fig. 7.1): Actuate the valve (see fig. 7.2).
50
Water connection