Packing List - Ego Power+ HT2410E Manual Del Usuario

◾
Never operate the hedge trimmer without proper guards,
plates, or other safety protective devices in place.
◾
Check damaged parts before further use of the hedge
trimmer. A guard or other part that is damaged should
be carefully checked to determine that it will operate
properly and perform its intended function. Check for
alignment of moving parts, binding of moving parts,
breakage of parts, mounting, and any other condition
that may affect its operation. A guard or other part that
is damaged should be properly repaired or replaced
by an authorized service center unless indicated
elsewhere in this manual.
◾
Check the blade and motor mounting bolts at frequent
intervals for proper tightness. Also, visually inspect
blade for damage (e.g., bent, cracked, and worn).
Replace the blade only with a blade from EGO
◾
Replace the blade if it is bent or cracked. An
unbalanced blade causes vibration that could damage
the motor drive unit or cause personal injury.
◾
If the equipment should start to vibrate abnormally,
stop the motor and check immediately for the cause.
Vibration is generally a warning of trouble.
◾
The trimmer shall be used to cut stems less than
(26mm) thick.
◾
Trim only in daylight or in good artificial light.
◾
Remove or disconnect battery before servicing,
cleaning, or removing material from the hedge trimmer.
◾
Do not wash with a hose; avoid getting water in motor
and electrical connections.
◾
When servicing use only identical replacement parts
listed in this manual. Use of parts which do not meet
the original equipment specifications may lead to
improper performance and compromised safety.
◾
Follow instructions for lubricating and changing
accessories.
◾
Keep handles dry, clean and free from oil and grease.
◾
Save these instructions. Refer to them frequently and
use them to instruct others who may use this tool. If
you loan this tool to someone else, also loan these
instructions to them to prevent misuse of the product
and possible injury.
SAVE THESE INSTRUCTIONS!
.
TM
56 VOLT LITHIUM-ION CORDLESS HEDGE TRIMMER— HT2410E
SPECIFICATIONS
Model
Voltage
No-Load Speed
Blade Length
Cutting Capacity
Weight (without battery pack)
Measured sound power level L
Sound pressure level at
operator's position L
PA
Guaranteed sound power level L
(according to 2000/14/EC)
Front Handle
Vibration a
h
Rear Handle
◾
The declared vibration total value has been measured
in accordance with a standard test method and may be
used for comparing one tool with another;
◾
The declared vibration total value may also be used in
a preliminary assessment of exposure.
NOTICE:
The vibration emission during actual use of the
power tool can differ from the declared value in which the
tool is used; In order to protect the operator, user should wear
gloves and ear protectors in the actual conditions of use.

PACKING LIST

PART NAME
Hedge Trimmer
Shield
Operator's manual
HT2410E
56 V
1500 /min
61 cm
26 mm
3.04 kg
94,5 dB(A)
K=1,5 dB(A)
WA
83,9 dB(A)
K=3,0 dB(A)
96 dB(A)
WA
1,8 m/s
2
K=1,5 m/s
2
1,7 m/s
2
K=1,5 m/s
2
QUANTITY
1
1
1
7
EN