Ecco 12+ Pro Vantage Serie Manual Del Usuario página 9

"Safety Director On/Off" - Press once to turn the Safety Director on or off.
"Safety Director Pattern Select" - Once the Saftey Director is activated, press this pattern select button to cycle to the
"Front Worklight (Takedown)" - Toggle press will activate/deactivate front worklight function. Long press for two seconds
"Back Worklight" - Toggle press will activate/deactivate rear worklight function. Long press for two seconds to activate/
"Left Worklight (Alley)" - Toggle press will activate/deactivate rear left worklight function. Long press for two seconds
"Right Worklight (Alley)" - Toggle press will activate/deactivate right worklight function. Long press for two seconds to
Special Features:
Touchpad Backlight
Reset the Lightbar back to Factory Setting: Press SEL button 8 times. The lightbar will flash 3 times and will reset back to
factory settings.
To limit the lightbar to R65 flash patterns, press SEL 5 times and bar will flash twice.
Safety Director Module Selection
Safety Director Front/Rear Selection
next Safety Director flash pattern. There is a 5 second delay between the controller
and the lightbar. Press and hold for 3 seconds to return to the prior flash pattern.
The lightbar will store the last flash pattern used.
to activate/deactivate front cut.
deactivate back cut.
to activate/deactivate left cut.
activate/deactivate right cut.
To change the number of modules used in the safety director, press and hold
5 to 10 modules.
5 6 7
7 modules
Press to turn on the safety director.
Press and hold , once the corner LEDs light, tap
Example
8
9 10
- tap
5 6 7 8
9
9 modules
to cycle front, rear or both.
to select
10
Page 9 of 14