Frico ADEA Manual De Instrucciones página 26

GB
Measured value menu
Measured room
temperature
Measured outdoor temperature
Fan mode
(0=No fan, 1=Low speed,
2=Medium speed, 3=High speed)
Programme control
(U=weekly programme, _=No
time controlled programme)
Status heating stage
(0=No heat, 1=Half power, 2=Full
power)
Status door
(CL=Closed door, OP=Open door)
Alarm
(0=No alarm, ATT=Alarm) See
above for acknowledging alarms
Day and time
(the time is changed automatically
for summer and winter time and
leap years)
Month, date and year
Week number
(Calculated automatically)
Desired values
The regulator controls the room temperature
to the required temperature setting (desired
value). To allow for energy savings, the
regulator has three desired values that
determine the temperature for the various
preset times that have been defined in the
weekly programme. The desired values are
DAY, NIGHt and SAVE.
In the measured value menu, the "PROG"
display shows "U" if the weekly programme is
active, otherwise "_". See an overview of the
menus above. When the weekly programme is
not selected, the regulator selects the default
operation position "DAY".
26
ADEA
Pressing the SELECT button once in the main
menu displays the current desired value. By pres-
sing the arrow keys one or more times you can
switch between the desired values.
Press the SET button and adjust using the
arrow keys to set a desired value.
The current desired value is shown here
Weekly programme
The weekly programme allows the option
of controlling the temperature for various
times of the day, for example, to drop the
temperature during the night, or to save
energy during times when nobody is present.
It is very convenient not having to think
about saving energy for set periods of the day
during the week.
The weekly programme has six time settings
where each time can be set to apply for
an optional day of the week. You can also
select the desired value to be engaged for
each time setting. The regulator has two
weekly programmes, where one of them can
be selected as active for switching between
desired values.
The displays below show the default settings
for the weekly programme in the regulator.
However, the regulator is normally set for
weekly programme 0, i.e. no programme is
active and no weekly programme times are
displayed. To change the weekly programme,
go to the "WPno" display and press the
SET button. Now switch to the required
programme (1 or 2) using the arrow keys.
Confirm your selection
DAY Desired value = 18°C
NATT Desired value = 15°C
SPAR Desired value = 12°C