Cleaning And Maintenance; Technical Specifications - cecotec Cumbia Power Espresso 20 Barista Cream Manual De Instrucciones

ENGLISH
The froth indicator will light up and the dot indicator will start flashing to remind you to return
the dial to starting position.
After you turn it, the device will return to standby mode.
Restoring default settings
Long press the four buttons (On/off, grind, single and double) at the same time. The device
will beep and all four indicator will flash at the same time. With this, the device will return to
default settings

4. CLEANING AND MAINTENANCE

Disconnect the appliance from the power supply and allow it to cool down before cleaning.
Use a soft, damp cloth to clean the product's surface.
Do not immerse the appliance in water or other liquid.
Do not use abrasive scouring pads, powders or cleaners. Use a moisture-proof sponge to
scrub the dirt.
After each use, clean all the detachable parts in water and dry them thoroughly.
Note: The removable water tank cannot be washed in the dishwasher.
Use the provided accessory to clean the steam conduct after each use, to eliminate any
residues.
5. TROUBLESHOOTING
Problem Cause
Nothing is displayed in Check if the device is plugged
the screen. in.
The indicator light on the The coffee bean tank is not
device's front panel is red. correctly fixed into placed.
Water stains can be The water tank or the
found on the bottom of cup-holder tray are not fixed
the machine. into place or are full.
44 POWER ESPRESSO 20 BARISTA CREAM
Solution
Plug the device in and make
sure it is turned on.
Assemble it correctly.
Make sure the water tank and
the cup-holder tray are fixed
into place. In case they are
correctly fixed into place and
the cup-holder tray is empty
and the problem is still not
solved, send the device to be
repaired. Do not try to repair
it yourself.
The device emits a ticking This is perfectly normal.
sound when turned This sound is produced by
on and a hiss when a correct operation of the
dispensing coffee. control valve.
The funnel does not Too much coffee powder or
dispense coffee or too fine.
dispense it drop by drop.
Coffee comes out without Coffee beans are damp or too
froth and watery. coarse.
No steam comes out the The steam nozzle is blocked
device. or the device has not been
pre-heated.
After steam is released, After dispensing steam,
the device does not allow the device needs to release
you to make coffee and pressure and lower its
it starts to pump water temperature. While this
automatically. is being done, no other
operations can be performed.

6. TECHNICAL SPECIFICATIONS

Reference number: 01589
Product: Cumbia Power Espresso 20 Barista Cream
Rated Power (coffee): 1380-1550 W
Rated Power (steam): 150 W
220-240 V~, 50/60 Hz
ENGLISH
The amount of coffee powder
should not exceed the limit.
Change the coffee bean's
setting to a correct value. Do
not try to press the coffee
powder with excessive force.
Use fresh coffee beans and a
moderate amount of coffee
powder.
The device will only emit
steam after it has been
pre-heated. The device needs
to be descaled. Clean the
steam nozzle with a cleaning
needle.
It takes 20-30 s to release
the pressure and reduce the
temperature. After this, the
indicator on the control panel
will return to normal and you
can brew coffee again.
POWER ESPRESSO 20 BARISTA CREAM 45