Technical Problems; Troubleshooting - Sistem-Air JOLLY Manual De Instalación, Uso Y Mantenimiento

10.1 Troubleshooting

Problem
The suction unit
The power supply
does not start is switched off
The start push-button of the
unit is not activated
The electrified hose is plugged
incorrectly (Jolly Contact only)
The thermal relay of the motor
triggers
Fuse burnt-out
Weak air suction Hose and cleaning
accessories broken
The dust bag needs
to be replaced
The dust bag is positioned
incorrectly in the housing
Dust bag worn
The fitting of the lower cover
is damaged or incorrectly
positioned
The motor protection filter
is dirty
Hose or accessories
obstructed
The lower cover is incorrectly
assembled
The air exhaust is obstructed
Installation, use and maintenance guide

10 - TECHNICAL PROBLEMS

Possible causes
28
Possible corrective measure
Switch on the power supply
Press the start push-button
Plug correctly the electrified
hose in the housing
Allow several minutes for
motor cooling
Unscrew the fuse cover
and replace it
Check if the hose and the
accessories are integral and
replace them if needed
Replace the dust bag
Check the correct position of
the bag in the container guides
and of the fitting of the pipe
union
Replace the dust bag
Check if the fitting is integral
and correctly positioned
Check and clean if needed
Check and clean if needed
Check and close the cover
correctly
Contact the Technical Service
Jolly-Jolly Contact 01-04/01