Securing Child - Nuna norr Manual De Instrucciones

Rearward Facing Mode Only
Rearward Facing Child height 40cm-105cm/
Child weight≤18kg
Recline position Position 1-7
1
Press the rotating button to rotate the seat facing
the rear of the vehicle. (15)
Please recline the seat to be in positions 3
through 7 for ease of rotation.
2
Rearward facing mode assembled as (16).
The ISOFIX connectors must be attached and
locked onto the ISOFIX anchor points. (16)-1
The load leg must be installed correctly with
green indicator. (16)-2
Height Adjustment
for Head Support and Shoulder Harnesses
Check that shoulder harness straps are set at the
proper height.
Squeeze the head support adjustment lever (17),
while pulling up or down on the head support until it
snaps into one of the 8 positions. The head support
positions are shown as (18).
Shoulder harness straps must be at a height nearest
to your childs shoulders (19), but not above the
shoulder line (20).
If the shoulder harness straps are not at the proper
height, the child might be ejected the enhanced child
restraint if there is a crash.
13
NORR instructions

Securing Child

Rotate the seat to the side to make it easier to put in
or carry out the baby. (26) After the child is placed
into the seat, check whether the shoulder harness
straps are at proper height. Please rotate the seat
backwards and lock it after fixing the baby.
1
While pressing the harness adjustment button
located at the front of the enhanced child
restraint, pull the two shoulder harness straps of
the enhanced child restraint. (21)
2
Unlock the buckle of the harnesses by pressing
the red button. (22)
3
Fix the buckles on the both sides of seat to make
placing the baby more convenient. (23)
4
Use Infant part.
Infant part is for children's protection. (24)
Detach the snaps on the
head support to remove
the head portion of the
infant part.
To use the Infant
part, please refer
to the following
requirements: Child
height 40cm–60cm/
Child weight≤ 13kg.
The Infant part
Remove wedge by
increases side impact
detaching the snaps to
protection.
allow more space when
the infant does not fit
comfortably.
Remove the head
support portion of the
Infant part when the
child's head no longer
fits comfortably.
Remove the body portion
of the Infant part when
the infant's shoulders no
longer fit comfortably.
1
The wedge can be
used separately
without being
attached to the Infant
part to bolster the
2
infant's back for more
comfort.
14
NORR instructions