Starting The Trimmer - Toro 51484 Manual Del Usuario

4
Adjusting the Auxiliary
Handle, Trimmer Height,
and Base Position
No Parts Required
Procedure
•
To adjust the auxiliary handle height, release the auxiliary
handle latch, slide the auxiliary handle up or down to the
desired height, then secure the auxiliary handle in place by
closing the auxiliary latch
1. Auxiliary handle
2. Auxiliary handle latch
•
To adjust the trimmer height, open the height adjustment
latch, then slide the shaft up or down to desired height,
securing it in place with the latch
•
To adjust the position of the base, press down on the rotator
button located at the base of the shaft, then move the base
to face the desired direction
1. Rotator button
(Figure 4).
Figure 4
3. Height adjustment latch
(Figure 4).
(Figure 5).
Figure 5
Operation
Important:
The battery pack is not fully charged when
it is purchased. Before using the trimmer for the first time,
place the battery pack in the charger and charge until the
LED indicators turn green. Make sure to read all safety
precautions. With regular use, it will need shorter charging
time. If storing for a prolonged period of time, remove the
battery pack. When ready to use again, charge the battery
pack until the LED indicators turn green.

Starting the Trimmer

1. Align the tongue of the battery pack with the cavity in the
handle housing
g015655
1. Trigger handle
2. Tongue
2. Grasp the trigger handle
3. Push the battery pack into the handle until the latch locks
into place.
4. To start the trimmer, slide the lock switch back to the O
position, then squeeze the trigger (Figure 6).
g017507
7
(Figure 6).
Figure 6
3. Latch
(Figure 6).
g016190
N