Adjusting The Trimmer Height And Base Position; Starting The Trimmer; Stopping The Trimmer - Toro 51484 Manual Del Operador

4
Adjusting the Trimmer Height
and Base Position
No Parts Required
Procedure
•
To adjust the auxiliary handle height, release the auxiliary
handle latch, slide the auxiliary handle up or down to the
desired height, then secure the auxiliary handle in place by
closing the auxiliary latch (Figure 4).
1. Auxiliary handle
2. Auxiliary handle latch
•
To adjust the trimmer height, open the height adjustment
latch, then slide the shaft up or down to desired height,
securing it in place with the latch (Figure 4).
•
To adjust the position of the base, press down on the rotator
button located at the base of the shaft, then move the base
to face the desired direction (Figure 5).
1. Rotator button
Operation
Important: The battery pack is not fully charged when it
is purchased. Before using the trimmer for the first time,
place the battery pack in the charger and charge until the
LED indicators turn green. Make sure to read all safety
G015655
Figure 4
3. Height adjustment latch
G017507
Figure 5
precautions. With regular use, it will need shorter charging
time. If storing for a prolonged period of time, remove the
battery. When ready to use again, charge the battery pack
until the LED indicators turn green.

Starting the Trimmer

1. Align the tongue of the battery pack with the cavity in the
handle housing (Figure 6).
1. Trigger handle
2. Tongue
2. Grasp the trigger handle (Figure 6).
3. Push the battery pack into the handle until the latch locks
into place.
4. To start the trimmer, slide the lock switch back to the On
position, then squeeze the trigger (Figure 6).
2
1. Lock switch

Stopping the Trimmer

To stop the trimmer, release the trigger.
7
1
2
G016190
Figure 6
3. Latch
1
G016189
Figure 7
2. Trigger
3