Senco Fusion F-35XP Instrucciones De Empleo página 17

Red light flashes.
Note: if tool has jammed and the mechanism initiates an automatic recovery, the tool may make a series of clicks as it repositions
the driver. This is normal.
Red light fades every 1.4 seconds.
Tool will not start or runs slowly.
Tool does not drive fastener to desired
depth.
Tool runs but will not drive fastener.
Poor feed/ tool jamming.
Broken or worn driver.
Tool does not fully return.
TROUBLESHOOTING
Fastener jam.
Tool does not function.
Internal high temperature.
Battery is discharged or has dead cell.
Workpiece contact element is jammed.
Workpiece contact element or trigger
switches are damaged.
Improper depth-of drive setting.
Tool not pressed firmly against the
workpiece.
Drive application is too rigorous.
Pressure loss.
Battery is discharged or has a dead cell.
Nail jam in guidebody.
Mechanism requires repair.
Tool is overheated.
Driver tip not located above fastener.
Debris build-up in mechanism.
Driver tip not located above fastener.
Weak battery.
17
Tool will attempt to recover.
Did fastener drive ok?
**Remove Battery**
Check if nail is blocking next fastener.
Inspect magazine for bent nail.
Remove magazine and inspect guide body.
Return to service center for repair.
Allow tool to cool at least 15 minutes.
Tool will completely cool in 30 minutes.
Replace or recharge battery.
Remove battery, then inspect tool to as-
sure free movement of workpiece contact
element.
Return tool to authorized SENCO service
representative.
Refer to operators manual for proper
adjustment.
Hold tool firmly in place when driving
fastener.
Refer to operators manual for appropriate
applications.
Return tool to authorized SENCO service
representative.
Recharge or replace with fresh battery.
Refer to operators manual for jam-clearing
instructions.
Return tool to authorized SENCO service
representative.
Allow tool to cool and insert fresh battery.
Recharge battery and allow tool to auto-
matically retract driver.
Clean tool, clean magazine or install Parts
Kit.
Return tool to authorized SENCO service
representative.
Recharge battery and allow tool to auto-
matically retract driver.
EN