Threading Upper Thread - Proline SMART16 Manual De Instrucciones

1. Turn the hand wheel to raise the needle to its highest position. Hold the
needle and loosen the needle clamp screw. Remove the needle and
dispose of it responsibly.
2. Insert a new needle into the clamp with the flat side towards the correct
direction (to the back). Be sure to push the needle completely into the
clamp before tightening the needle clamp screw.
3. Tighten the needle clamp screw.
Caution: Needle direction must be correct and be sure to tighten the needle clamp screw to prevent
the needle from falling off the clamp.

THREADING UPPER THREAD

PRESSER FOOT REPLACEMENT
Caution:
Always switch off and disconnect the appliance from the power supply and remove the foot pedal when
replacing presser foot.
When replacing the presser foot, place the machine on a stable surface.
When putting down the presser foot, do not put your hand or finger under it to avoid injury.
Caution: Always switch off and disconnect it from
the power adapter and remove foot pedal when
threading the machine.
Turn the hand wheel to raise the needle to its highest
position.
Put a spool on the thread spindle, put on the thread
spindle cover and then pull out the thread.
Pull the thread and let is pass through the bobbin
winder tension disk.
Guide the thread go through the groove and pull it up
towards the take-up lever.
Feed the thread through the hole in the lever and pull
straight down towards the needle.

Feed the thread through the hole in the needle holder,
then through the eye of the needle from the front side
to the back and pull out 10cm to the back.
EN - 4