Winding The Bobbin - Proline SMART16 Manual De Instrucciones

6.
Sewing sleeves
This machine can be used to sew sleeves or any narrow openings in garment. Pull
out the drawer and position the garment over the sewing arm.
7.Manual buttonhole
a.Put the cloth under the presser foot and lower the presser foot on the cloth where you need to sew
buttonhole, then choose the 15
b.Turn on the
appliance and
sew 5-6 stitches
at low speed,
then turn off the
appliance.
8.Drawer
This drawer is an accessory storage compartment which can be slided out. You can store
spare bobbins, needles, ect. in it.

WINDING THE BOBBIN

Caution:
During bobbin winding, no thread on the needle / take-up lever is allowed. Please take thread off it before
bobbin winding.
Before bobbin winding, raise the presser foot.
1. Put a spool of thread on spool pin.
2. Guide the thread through the bobbin winder tension disk on the upper side of the machine.
3. Put the bobbin on the bobbin winder pin, wind thread clockwise around bobbin several times.
4. Push bobbin to the left.
5. Switch on the machine to start winding.
6. Switch off the machine to stop winding after your desired volume of thread has winded on bobbin.
7. Push bobbin away from bobbin winder stop, take bobbin off the pin and cut the thread.
th
stitch.
th
c.Choose the 16
stitch, turn on the
appliance and sew
on the cloth in
suitable length, then
turn off the
appliance. Note that
try to keep sewed
stitch in a straight
line.
th
d.Choose the 15 e.Raise the
stitch, then turn
on the
appliance and
sew 5-6 stitches
at low speed,
then turn off the
appliance.
EN - 7
f.Choose the 16
presser foot, stitch,then turn on
rotating the the appliance and
cloth 180°. sew till
buttonhole is fully
sewed.
th